Markindia Marking Systems


Contact Us

Markindia Marking Systems

33, 34, Darshan Vihar, Near Deshmukh Hospital, Devlai Chowk, Beed Bypass Road, Aurangabad, Maharashtra - 431005, India

Mobile : +91-9421839020, +91-9421761007

Phone : +91-0240-2653515

Select Language

EnglishFrenchGermanItalianPortugueseSpanish

FAQs


MarkIndia Strives to maintain integrity in its products quality, customer satisfaction, executed performance.

Questions & Answers
Q - Can I mark round parts?
A - Yes by rolling on a bench marker or by using contour blocks.
Q - Can I mark plated parts?
A - Yes, as long as the parts conduct electricity.
Q - Can I mark anodized parts?
A - Not after anodizing. Mark deep before anodizing and the mark will show through after the process.
Q - Can I mark black oxide surfaces?
A - Yes, in most cases using low voltage, high pressure and proper electrolytes.
Q - Is the electrolyte harmful?
A - No, it may stain clothes but it will wash out. If you swallow it drink a lot of water and see a doctor.
Q - How deep can I go?
A - An AC mark is around 0.0003 deep. A DC etch can go as deep as 0.005 or more but generally 0.001 is
considered deep.
Q - What is an etch?
A - The dark mark is a combination of an etch and a plate.
Q - How long will the stencil last?
A - Depending on the kind and use of the configuration and the depth required you can get from one to thousands of impressions.
Q - How clean does the surface of the part have to be?
A - Just free of sharp particles which would cut the stencil. Light oil is fine.
Q - How rough a surface can you mark on?
A - A reasonably smooth forged or cast surface
Q - Will this method of marking cause corrosion?
A - Yes, if not neutralized with the proper neutralizers.